CDC2509

3.3V PHASELOCK LOOP CLOCK DRIVER

SCAS580C − OCTOBER 1996 − REVISED DECEMBER 2004

4

POST OFFICE BOX 655303

−0.5 V to 4.6 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

−0.5 V to 6.5 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Voltage range applied to any output in the high

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

−50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

±50 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

±100 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

0.7 W

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

−65

°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES:

1. The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.

2. This value is limited to 4.6 V maximum.

3. The maximum package power dissipation is calculated using a junction temperature of 150

°C and a board trace length of 750 mils.

For more information, refer to the Package Thermal Considerations application note in the ABT Advanced BiCMOS Technology Data

Book, literature number SCBD002.

recommended operating conditions (see Note 4)

MIN

MAX

UNIT

Supply voltage, VCC

3

3.6

V

High-level input voltage, VIH

2

V

Low-level input voltage, VIL

0.8

V

Input voltage, VI

0

VCC

V

High-level output current, IOH

−12

mA

Low-level output current, IOL

12

mA

Operating free-air temperature, TA

0

70

°C

NOTE 4: Unused inputs must be held high or low to prevent them from floating.

electrical characteristics over recommended operating free-air temperature range (unless

otherwise noted)

PARAMETER

TEST CONDITIONS

VCC

MIN

TYP‡

MAX

UNIT

VIK

II = −18 mA

3 V

−1.2

V

IOH = −100 µA

MIN to MAX

VCC−0.2

VOH

IOH = −12 mA

3 V

2.1

V

VOH

IOH = − 6 mA

3 V

2.4

V

IOL = 100 µA

MIN to MAX

0.2

VOL

IOL = 12 mA

3 V

0.8

V

VOL

IOL = 6 mA

3 V

0.55

V

II

VI = VCC or GND

3.6 V

±5

µA

ICC§

VI = VCC or GND,

IO = 0, Outputs: low or high

3.6 V

10

µA

∆ICC

One input at VCC − 0.6 V,

Other inputs at VCC or GND

3.3 V to 3.6 V

500

µA

Ci

VI = VCC or GND

3.3 V

4

pF

Co

VO = VCC or GND

3.3 V

6

pF

‡ For conditions shown as MIN or MAX, use the appropriate value specified under recommended operating conditions.

§ For ICC of AVCC, see Figure 5.