LM81 datasheet(11/43 Pages) TI1

11 / 43 page

LM81

www.ti.com

SNAS011E – JUNE 1999 – REVISED FEBRUARY 2002

TEST CIRCUIT

Figure 6. Digital Output Load Test Circuitry

FUNCTIONAL DESCRIPTION

GENERAL DESCRIPTION

The LM81 provides 6 analog inputs, a temperature sensor, a Delta-Sigma ADC (Analog-to-Digital Converter), a

DAC output, 2 fan speed counters, WATCHDOG registers, and a variety of inputs and outputs on a single chip. A

two wire Serial Bus interface is included. The LM81 performs power supply, temperature, fan control and fan

monitoring for personal computers.

The analog inputs are useful for monitoring several power supplies present in a typical computer. The LM81

includes internal resistor dividers that scale and/or offset external Vccp, +2.5V, +3.3V, +5.0V and +12V power

supply voltages to a 3/4 scale nominal ADC output. The LM81 ADC then continuously converts the scaled inputs

to 8-bit digital words. Measurement of negative voltages (such as -5V and -12V power supplies) can be

accommodated with an external resistor divider applied to the Vccp2 input. Temperature is converted to a 9-bit or

12-bit two’s-complement digital word with a 0.5

˚C LSB or 0.0625˚C LSB, respectively.

Fan inputs measure the period of tachometer pulses from the fans, providing a higher count for lower fan

speeds. The fan inputs are Schmitt-Trigger digital inputs with an acceptable range of 0V to V+ and a transition

level of approximately V+/2. Full scale fan counts are 255 (8-bit counter) and this represents a stopped or very

slow fan. Nominal speeds, based on a count of 153, are programmable from 1100 to 8800 RPM on FAN1 and

FAN2. Schmitt-Trigger input circuitry is included to accommodate slow rise and fall times. A 0V to 1.25V DAC

output voltage range can be used for control of fan speed.

Submit Documentation Feedback

Product Folder Links: LM81

LM81 Datasheet(PDF) 11 Page - Texas Instruments