CS10.481

C–Series

Nov. 2006 / Rev.1.1 DS-CS10.481-EN

All parameters are specified at 48V, 5A, 230Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

18/20

The unit is designed to supply any kind of load, including unlimited capacitive and inductive loads.

The power supply can be put in series to increase the output voltage.

Fig. 25-5 Schematic for series operation

Instructions for use in series:

Earth

Unit A

AC

DC

Unit B

AC

DC

-

+

-

+

Load

+

-

a)

It is possible to connect as many units in series as needed,

providing the sum of the output voltage does not exceed

150Vdc.

b)

Voltages with a potential above 60Vdc are not SELV any

more and can be dangerous. Such voltages must be installed

with a protection against touching.

c)

For serial operation use power supplies of the same type.

d)

Earthing of the output is required when the sum of the

output voltage is above 60Vdc.

e)

Keep an installation clearance of 15mm (left/right) between

two power supplies and avoid installing the power supplies

on top of each other.

Note: Avoid return voltage (e.g. from a decelerating motor or

battery) which is applied to the output terminals.

The power supply shall not be used in parallel to increase the output power.

Power supplies can be paralleled for 1+1 redundancy to gain a higher system availability. Redundant systems require

a certain amount of extra power to support the load in case one power supply unit fails. The simplest way is to put

two C-Series power supplies in parallel. In case one power supply unit fails, the other one is automatically able to

support the load current without any interruption. This simple way to build a redundant system has two major

disadvantages:

-

The faulty power supply can not be recognized. The green LED will still be on since it is reverse-powered from

the other power supply.

-

It does not cover failures such as an internal short circuit in the secondary side of the power supply. In such a -

virtually nearly impossible - case, the defective unit becomes a load for the other power supplies and the output

voltage can not be maintained any more.

This can only be avoided by utilizing decoupling diodes which are included in the decoupling module YR2.DIODE or

redundancy module YRM2.DIODE.

Recommendations for building redundant power systems:

a)

Use separate input fuses for each power supply.

b)

Monitor the individual power supply units. A DC-ok lamp and a DC-ok contact is included in the redundancy

module YRM2.DIODE. This feature reports a faulty unit.

c)

When possible, connect each power supply to different phases or circuits.