APE

■Right angle terminals

Standard

（M）

■Mounting of Switch

●Use PC boards with hole diameter of 1mm.

●Do not bend the terminal pins before mounting the switch on

the PC board.

●After mounting the switch, do not place the device in such a

way that the device weight will be applied on to the actuator of

the switch.

●Do not apply load exceeding 12.7 N to the actuator. If load

exceeding 12.7 N is expected to be applied to the actuator,

please use a Bracket (optional accessory sold separately).

Maximum load will be 29.4 N when a Bracket is used.

●Use Bracket 140000640314 or 140000640318 for side-by-

side mounting.

●To increase mounting strength, use Bracket 140000640315.

●PC Hole Layouts will change depending on the Bracket.

Please refer to P.249.

1 pole

2 poles

●The space between the terminal rows are available in

two dimensions: 0.2 inches (5.08 mm) and 0.3 inches

(7.62 mm).

 [Example]  0.2-inch pitch : APE1F-5M-10-Z

0.3-inch pitch : APE1F-6M-10-Z

Refer to P.253.

：Optional Accessories.