DP7261 datasheet(9/15 Pages) COPAL

9 / 15 page

DP7261

Doc. No. MD-2122 Rev. E

Characteristics subject to change without notice

The basic sequence of the three byte instructions is

illustrated in Figure 8. These three-byte instructions

exchange data between the WCR and one of the Data

Registers. The WCR controls the position of the wiper.

The response of the wiper to this action will be

delayed by tWRL. A transfer from the WCR (current

wiper position), to a Data Register is a write to non-

volatile memory and takes a minimum of tWR to

complete. The transfer can occur between one of the

potentiometers and one of its associated registers; or

the transfer can occur between both potentiometers

and one associated register.

Four instructions require a two-byte sequence to

complete, as illustrated in Figure 7. These instructions

transfer data between the host/processor and the

DP7261; either between t he host and one of the data

registers or directly between the host and the Wiper

Control Register. These instructions are:

— XFR Data Register to Wiper Control Register

This transfers the contents of one specified Data

— XFR Wiper Control Register to Data Register

This transfers the contents of the specified Wiper

Control Register to the specified associated Data

— Global XFR Data Register to Wiper Control

This transfers the contents of all specified Data

Registers

the

associated

Wiper

Control

Registers.

— Global XFR Wiper Counter Register to Data

This transfers the contents of all Wiper Control

Registers

the

specified

associated

Data

Registers.

INCREMENT/DECREMENT COMMAND

The final command is Increment/Decrement (Figure 9

and 10). The Increment/Decrement command is differ-

ent from the other commands. Once the command is

issued the master can clock the selected wiper up

and/ or down in one segment steps; thereby providing

a fine tuning capability to the host. For each SCK

clock pulse (tHIGH) while SI is HIGH, the selected wiper

will move one resistor segment towards the RH

terminal. Similarly, for each SCK clock pulse while SI

is LOW, the selected wiper will move one resistor

segment towards the RL terminal.

See Instructions format for more detail.

Figure 7. Two-Byte Instruction Sequence

Figure 8. Three-Byte Instruction Sequence

Figure 9. Increment/Decrement Instruction Sequence

R1 R0 P1

ID3 ID2 ID1 ID0

Device ID

Internal

Instruction

Opcode

Address

Pot/WCR

Address

R1 R0

ID3 ID2 ID1 ID0

Device ID

Internal

Instruction

Opcode

Address

Data

Address

Pot/WCR

Address

WCR[7:0]

Data Register D[7:0]

P1 P0

D6 D5 D4 D3 D2

D1 D0

ID3 ID2 ID1 ID0

Device ID

Internal

Instruction

Opcode

Address

Data

Address

Pot/WCR

Address

010

A1 A0

R0 P1 P0

DP7261 Datasheet(PDF) 9 Page - Copal Electronics

DP7261 Datasheet(HTML) 9 Page - Copal Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Datasheet Download

Link URL