LOC B

in tool. Insert female die holding pin. See

Figure 5.

Figure 5

2.4. Die Removal Hand Tool No. 59500

1. Remove female die holding pin.

2. Close handles until male die holding screw is

visible. See Figure 6.

3. Turn male die holding screw slot in a vertical

position. See Figure 6.

4. Push die set up with a small screwdriver or

drift pin just enough to permit female die to be

pulled out of tool.

5. Remove male die and insert die holding pin

back into tool.

Figure 6

2.5. Die Removal Pneumatic Tool No. 69270·1 Mod. 2

1. Remove female die holding pin.

2. Depress take-up lever until male die holding

screw is visible. See Figure 6.

3. With take-up lever depressed, turn male die

holding screw slot in a vertical position. See

Figure 6.

4. Push die set up with a small screwdriver or

drift pin just enough to permit female die to be

pulled out of tool.

5. Remove male die and insert die holding pin

back into tool.

2.6. Wire Stripping And Crimping Procedures

A. Wire Stripping

1. Strip shielded wire as shown in Figure 7.

Figure 7

2. Strip ground wire to dimensions given in Figure

8.

Figure 8

B. Crimping Procedures

1. Place ferrule on shielded wire as shown in

Figure 9. Flare the braid so that it will pass over

and around support sleeve of ferrule.

Ferrule

Number

Recommended Ground

Strip

Length

No. of

Wires

Max. Ins

Dia

327192

One # 24

.063

1/4 Inch

Min.

Two # 24

.065

One # 22

.068

323930

thru

323934

One # 20

.078

One # 22

.078

Two # 22

.068

327137

thru

327141

One # 18

No Limit

on Insul

Diameter

7/16 Inch

Min

One # 20

Two # 20

One # 22

Two # 22

4 of 8

408-1662

Rev A