External Components Description

Components

Functional Description

1R

B

Prevents currents from entering the amplifier’s non-inverting input which may be passed through to the

load upon power down of the system due to the low input impedance of the circuitry when the

undervoltage circuitry is off. This phenomenon occurs when the supply voltages are below 1.5V.

2R

i

Inverting input resistance to provide AC gain in conjunction with R

3R

f

Feedback resistance to provide AC gain in conjunction with R

4C

i

(Note 13)

Feedback capacitor which ensures unity gain at DC. Also creates a highpass filter with R

1/(2

πR

5C

S

Provides power supply filtering and bypassing. Refer to the Supply Bypassing application section for

proper placement and selection of bypass capacitors.

6R

V

(Note 13)

Acts as a volume control by setting the input voltage level.

7R

IN

(Note 13)

Sets the amplifier’s input terminals DC bias point when C

create a highpass filter at f

8C

IN

(Note 13)

Input capacitor which blocks the input signal’s DC offsets from being passed onto the amplifier’s inputs.

9R

SN

(Note 13)

Works with C

10

C

SN

(Note 13)

Works with R

The pole is set at f

11

L (Note 13)

Provides high impedance at high frequencies so that R may decouple a highly capacitive load and reduce

the Q of the series resonant circuit. Also provides a low impedance at low frequencies to short out R and

pass audio signals to the load. Refer to

Figure 4.

12

R (Note 13)

13

R

A

Provides DC voltage biasing for the transistor Q1 in single supply operation.

14

C

A

Provides bias filtering for single supply operation.

15

R

INP

(Note 13)

Limits the voltage difference between the amplifier’s inputs for single supply operation. Refer to the Clicks

and Pops application section for a more detailed explanation of the function of R

16

R

BI

Provides input bias current for single supply operation. Refer to the Clicks and Pops application section

for a more detailed explanation of the function of R

17

R

E

Establishes a fixed DC current for the transistor Q1 in single supply operation. This resistor stabilizes the

half-supply point along with C

18

R

M

Mute resistance set up to allow 0.5 mA to be drawn from pin 6 or 11 to turn the muting function off.

→ R

Current curves in the Typical Performance Characteristics section.

19

C

M

Mute capacitance set up to create a large time constant for turn-on and turn-off muting.

20

S

1

Mute switch that mutes the music going into the amplifier when opened.

Note 13: Optional components dependent upon specific design requirements.

Typical Performance Characteristics

THD+Nvs Frequency

DS100928-55

THD+Nvs Frequency

DS100928-56

THD+Nvs Output Power

DS100928-58

www.national.com

7