BTM430/431

Embedded Wireless Solutions Support

Center: http://ews-support.lairdtech.com

www.lairdtech.com/bluetooth

23

Laird Technologies

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

Part Number

Description

BTM430

Bluetooth AT Data Module (external antenna)

BTM431

Bluetooth AT Data Module (with integrated antenna)

DVK – BTM430

Development board with BTM430 module soldered in place

DVK – BTM431

Development board with BTM431 module soldered in place

7.1

General Comments

This is a preliminary datasheet. Please check with Laird Technologies for the latest information before

commencing a design. If in doubt, ask.

Refer to the schematic BTDMD-R-001.pdf for the Development Kit on the following two pages for examples of

typical pin connections. A pdf of the schematic can be downloaded from the product

web page.

The BTM430 and BTM431 modules are listed on the Bluetooth SIG website as qualified End Products.

Design

Name

Owner

Declaration

ID

Link to listing on the SIG website

BTM430,

BTM431

Laird

Technologie

s

B016510

https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=16510

It is a mandatory requirement of the Bluetooth Special Interest Group (SIG) that every product implementing

Bluetooth technology has a Declaration ID. Every Bluetooth design is required to go through the qualification

process, even when referencing a Bluetooth Design that already has its own Declaration ID. The Qualification

Process requires each company to registered as a member of the Bluetooth SIG – www.bluetooth.org

The following link provides a link to the Bluetooth Registration page:

https://www.bluetooth.org/login/register/

For each Bluetooth Design it is necessary to purchase a Declaration ID. This can be done before starting the

new qualification, either through invoicing or credit card payment. The fees for the Declaration ID will depend

on your membership status, please refer to the following webpage:

https://www.bluetooth.org/en-us/test-qualification/qualification-overview/fees

For a detailed procedure of how to obtain a new Declaration ID for your design, please refer to the following

SIG document:

https://www.bluetooth.org/DocMan/handlers/DownloadDoc.ashx?doc_id=283698&vId=317486

To start the listing, go to: https://www.bluetooth.org/tpg/QLI_SDoc.cfm

In step 1, select the option, Reference a Qualified Design and enter 16510 in the End Product table entry. You

can then select your pre-paid Declaration ID from the drop down menu or go to the Purchase Declaration ID

page, (please note that unless the Declaration ID is pre-paid or purchased with a credit card, it will not be

possible to proceed until the SIG invoice is paid.