BTM510/511 Multimedia Module

Datasheet

Embedded Wireless Solutions Support Center:

http://ews-support.lairdtech.com

www.lairdtech.com/ramp

22

© Copyright 2017 Laird. All Rights Reserved

Americas: +1-800-492-2320

Europe: +44-1628-858-940

Hong Kong: +852 2923 0610

The BTM510 and BTM511 modules are listed on the Bluetooth SIG website as qualified End Products.

Design

Name

Owner

Declaration

ID

Link to listing on the SIG website

BTM510,

BTM511

Laird

D023160

https://www.bluetooth.org/tpg/QLI_viewQDL.cfm?qid=23160

It is a mandatory requirement of the Bluetooth Special Interest Group (SIG) that every product implementing

Bluetooth technology has a Declaration ID. Every Bluetooth design is required to go through the qualification

process, even when referencing a Bluetooth Design that already has its own Declaration ID. The Qualification

Process requires each company to registered as a member of the Bluetooth SIG – www.bluetooth.org

The following link provides a link to the Bluetooth Registration page:

https://www.bluetooth.org/login/register/

For each Bluetooth Design it is necessary to purchase a Declaration ID. This can be done before starting the new

qualification, either through invoicing or credit card payment. The fees for the Declaration ID will depend on

your membership status, please refer to the following webpage:

https://www.bluetooth.org/en-us/test-qualification/qualification-overview/fees

For a detailed procedure of how to obtain a new Declaration ID for your design, please refer to the following SIG

document:

https://www.bluetooth.org/DocMan/handlers/DownloadDoc.ashx?doc_id=283698&vId=317486

To start the listing, go to: https://www.bluetooth.org/tpg/QLI_SDoc.cfm.

In step 1, select the option, Reference a Qualified Design and enter 16227 in the End Product table entry. You

can then select your pre-paid Declaration ID from the drop down menu or go to the Purchase Declaration ID

page, (please note that unless the Declaration ID is pre-paid or purchased with a credit card, it will not be

possible to proceed until the SIG invoice is paid.

Once all the relevant sections of step 1 are finished, complete steps 2, 3, and 4 as described in the help

document. Your new Design will be listed on the SIG website and you can print your Certificate and DoC.

For further information please refer to the following training material:

https://www.bluetooth.org/en-us/test-qualification/qualification-overview/listing-process-updates