LMC6001 datasheet(5/14 Pages) NSC

5 / 14 page

AC Electrical Characteristics

Limits in standard typeface guaranteed for T

J = 25˚C and limits in boldface type apply at the temperature extremes. Unless

otherwise specified, V

+ = 5V, V− = 0V, V

CM = 1.5V and RL > 1M.

Symbol

Parameter

Conditions

Typical

Limits (Note 5)

Units

(Note 4)

LM6001AI

LM6001BI

LM6001CI

Slew Rate

(Note 7)

1.5

0.8

V/µs

0.6

min

GBW

Gain-Bandwidth Product

1.3

MHz

φf

Phase Margin

Deg

Gain Margin

Input-Referred Voltage Noise

F = 1 kHz

nV/

√Hz

Input-Referred Current Noise

F = 1 kHz

0.13

fA/

√Hz

THD

Total Harmonic Distortion

F = 10 kHz, A

V = −10,

L = 100 kΩ,

O = 8VPP

0.01

Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the device is in-

tended to be functional but do not guarantee specific performance limits. For guaranteed specifications and test conditions, see the Electrical Characteristics. The

guaranteed specifications apply only for the test conditions listed.

Note 2: Applies to both single supply and split supply operation. Continuous short circuit operation at elevated ambient temperature can result in exceeding the maxi-

mum allowed junction temperature of 150˚C. Output currents in excess of ±30 mA over long term may adversely affect reliability.

Note 3: The maximum power dissipation is a function of TJ(max), θJA, and TA. The maximum allowable power dissipation at any ambient temperature is

PD = (TJ(max) −TA)/θJA.

Note 4: Typical values represent the most likely parametric norm.

Note 5: All limits are guaranteed by testing or statistical analysis.

Note 6: V+ = 15V, VCM = 7.5V and RL connected to 7.5V. For Sourcing tests, 7.5V ≤ VO ≤ 11.5V. For Sinking tests, 2.5V ≤ VO ≤ 7.5V.

Note 7: V+ = 15V. Connected as Voltage Follower with 10V step input. Limit specified is the lower of the positive and negative slew rates.

Note 8: For operating at elevated temperatures the device must be derated based on the thermal resistance

θJA with PD = (TJ −TA)/θJA.

Note 9: Human body model, 1.5 k

Ω in series with 100 pF.

Note 10: Do not connect the output to V+, when V+ is greater than 13V or reliability will be adversely affected.

Note 11: All numbers apply for packages soldered directly into a printed circuit board.

LMC6001 Datasheet(PDF) 5 Page - National Semiconductor (TI)

LMC6001 Datasheet(HTML) 5 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Datasheet Download

Link URL