TLE2142ACD datasheet(5/79 Pages) TI1

5 / 79 page

TLE214x, TLE214xA

EXCALIBUR LOW-NOISE HIGH-SPEED

PRECISION OPERATIONAL AMPLIFIERS

SLOS183D − FEBRUARY 1997 − REVISED OCTOBER 2012

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)†

Supply voltage, VCC+ (see Note 1)

22 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Supply voltage, VCC−

−22 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Differential input voltage, VID (see Note 2)

± 44 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (any input)

VCC+ to VCC− − 0.3 V

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input current, II (each input)

±1 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output current, IO

±80 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Total current into VCC+

80 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Total current out of VCC−

80 mA

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Duration of short-circuit current at (or below) 25°C (see Note 3)

unlimited

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Package thermal impedance, θJA (see Notes 4 and 5): D package

97.1°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . .

DW package

57.3°C/W

. . . . . . . . . . . . . . . . . . . . . . . .

N package

79.7°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . .

P package

84.6°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . .

PW package

108.4°C/W

. . . . . . . . . . . . . . . . . . . . . . .

Package thermal impedance, θJC (see Notes 4 and 5): FK package

5.6°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . . .

J package

15.1°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . .

JG package

14.5°C/W

. . . . . . . . . . . . . . . . . . . . . . . . .

U package

14.7°C/W

. . . . . . . . . . . . . . . . . . . . . . . . . .

Operating free-air temperature range, TA: C suffix

0°C to 70°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

I suffix

−40°C to 105°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

M suffix

−55°C to 125°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperature range

−65°C to 150°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Case temperature for 60 seconds: FK package

260°C

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds: D, DW, N, P, or PW package

260°C

. . . . .

Lead temperature 1,6 mm (1/16 inch) from case for 60 seconds: J or JG package

300°C

. . . . . . . . . . . . . . . .

† Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and

functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not

implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES: 1. All voltage values, except differential voltages, are with respect to the midpoint between VCC+ and VCC−.

2. Differential voltages are at IN+ with respect to IN −. Excessive current flows, if input, are brought below VCC− − 0.3 V.

3. The output may be shorted to either supply. Temperature and /or supply voltages must be limited to ensure that the maximum

dissipation rating is not exceeded.

4. Maximum power dissipation is a function of TJ(max),

θJA, and TA. The maximum allowable power dissipation at any allowable

ambient temperature is PD = (TJ(max) − TA)/

θJA. Operating at the absolute maximum TJ of 150°C can affect reliability.

5. The package thermal impedance is calculated in accordance with JESD 51-7 (plastic) or MIL-STD-883 Method 1012 (ceramic).

recommended operating conditions

C SUFFIX

I SUFFIX

M SUFFIX

UNIT

MIN

MAX

MIN

MAX

MIN

MAX

UNIT

Supply voltage, VCC±

±2

±22

±2

±22

±2

±22

Common mode input voltage V

VCC = 5 V

2.9

2.7

Common-mode input voltage, VIC

VCC± = ±15 V

−15

12.9

−15

12.7

−15

12.7

Operating free-air temperature, TA

−40

105

−55

125

°C

TLE2142ACD Datasheet(PDF) 5 Page - Texas Instruments

TLE2142ACD Datasheet(HTML) 5 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79

Datasheet Download

Link URL