LM5115MM datasheet(11/17 Pages) NSC

11 / 17 page

Error Amplifier and Soft-Start (FB,

CO, & COMP, SS) (Continued)

fier is configured as an open drain output it can be disabled

by connecting FB to ground. The current sense amplifier and

current limiting function will be described in a later section.

Leading Edge Pulse Width

Modulation

Unlike conventional voltage mode controllers, the LM5115

implements leading edge pulse width modulation. A current

source equal to 3 times the I

SYNC current is used to charge

the capacitor connected to the RAMP pin as shown in Figure

4. The ramp signal and the output of the error amplifier

(COMP) are combined through a resistor network to produce

a voltage ramp with variable dc offset (CRMIX in Figure 4).

The high side MOSFET which drives the HS pin is held in the

off state at the beginning of the phase signal. When the

voltage of CRMIX exceeds the internal threshold voltage CV,

the PWM comparator turns on the high side MOSFET. The

HS pin rises and the MOSFET delivers current from the main

converter phase signal to the output of the auxiliary regula-

tor. The PWM cycle ends when the phase signal falls and

power is no longer supplied to the drain of the high side

MOSFET.

Leading edge modulation of the auxiliary PWM controller is

required if the main converter is implemented with peak

current mode control. If trailing edge modulation were used,

the additional load on the transformer secondary from the

auxiliary channel would be drawn only during the first portion

of the phase signal pulse. Referring to Figure 5, the turn off

the high side MOSFET of the auxiliary regulator would cre-

ate a non-monotonic negative step in the transformer cur-

rent. This negative current step would produce instability in a

peak current mode controller. With leading edge modulation,

the additional load presented by the auxiliary regulator on

the transformer secondary will be present during the latter

portion of the phase signal. This positive step in the phase

signal current can be accommodated by a peak current

mode controller without instability.

20134914

FIGURE 4. Synchronization and Leading Edge Modulation

20134920

FIGURE 5. Leading versus Trailing Edge Modulation

LM5115MM Datasheet(PDF) 11 Page - National Semiconductor (TI)

LM5115MM Datasheet(HTML) 11 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Datasheet Download

Link URL