3

Assembly Instruction

.276

7.01

1

2

3

.098

2.50

1

2 3

4

1

2 3

4

5

1. SLIDE CLAMP NUT 1 , THINNER WASHER 2 & GASKET 3 OVER CABLE. STRIP

CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID

TO PERMIT ASSEMBLY OF CLAMP.

2. SLIDE BRAID CLAMP 4 OVER BRAID & SEAT AGAINST CABLE. FORM BRAID OVER

CLAMP NUT. TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC & CENTER

CONDUCTOR TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR.

3. SOLDER CONTACT 5 TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT

OVER HEAT DIELECTRIC. INSERT CABLE ASSEMBLY INTO BODY 6 & TIGHTEN.

6

SOLDER

ASSEMBLY PROCEDURES

PE4067 REV 1.4

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,

inventory and certifications: TNC Male Connector Clamp/Solder Attachment for RG58, RG55, RG141, RG142, RG223,

RG400, RG303, PE-C195, PE-P195, LMR-195 PE4067

RF Connectors Technical Data Sheet

PE4067

TNC Male Connector Clamp/Solder Attachment

for RG58, RG55, RG141, RG142, RG223, RG400,

RG303, PE-C195, PE-P195, LMR-195