AD7685ARMZ datasheet(21/29 Pages) AD

21 / 29 page

AD7685

Data Sheet

CS MODE 4-WIRE, NO BUSY INDICATOR

This mode is usually used when multiple AD7685s are

connected to an SPI-compatible digital host.

A connection diagram example using two AD7685s is shown in

Figure 38, and the corresponding timing is given in Figure 39.

With SDI high, a rising edge on CNV initiates a conversion,

selects the CS mode, and forces SDO to high impedance. In this

mode, CNV must be held high during the conversion phase and

the subsequent data readback (if SDI and CNV are low, SDO is

driven low). Prior to the minimum conversion time, SDI could

be used to select other SPI devices, such as analog multiplexers,

but SDI must be returned high before the minimum conversion

time and held high until the maximum conversion time to

avoid the generation of the BUSY signal indicator. When the

conversion is complete, the AD7685 enters the acquisition phase

and powers down. Each ADC result can be read by bringing low

its SDI input, which consequently outputs the MSB onto SDO.

The remaining data bits are then clocked by subsequent SCK

falling edges. The data is valid on both SCK edges. Although the

rising edge can be used to capture the data, a digital host using

the SCK falling edge will allow a faster reading rate, provided it

has an acceptable hold time. After the 16th SCK falling edge, or

when SDI goes high, whichever is earlier, SDO returns to high

impedance and another AD7685 can be read.

If multiple AD7685s are selected at the same time, the SDO

output pin handles this contention without damage or induced

latch-up. Meanwhile, it is recommended to keep this contention

as short as possible to limit extra power dissipation.

DATA IN

CLK

CS1

CONVERT

CS2

DIGITAL HOST

CNV

SCK

SDO

SDI

AD7685

CNV

SCK

SDO

SDI

AD7685

Figure 38. CS Mode 4-Wire, No BUSY Indicator Connection Diagram

SDO

D15

D14

D13

tDIS

SCK

tHSDO

tDSDO

tEN

CONVERSION

ACQUISITION

tCONV

tCYC

tACQ

ACQUISITION

SDI(CS1)

CNV

tSSDICNV

tHSDICNV

tSCK

tSCKL

tSCKH

D15

D14

SDI(CS2)

Figure 39. CS Mode 4-Wire, No BUSY Indicator Serial Interface Timing

Rev. D | Page 20 of 28

AD7685ARMZ Datasheet(PDF) 21 Page - Analog Devices

AD7685ARMZ Datasheet(HTML) 21 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Datasheet Download

Link URL