sames

PM2005M/P

4/12

http://www.sames.co.za

http://www.sames.co.za

SETTING UP THE MODULE FOR ENERGY

MEASUREMENT

Figure 3 below shows a typical setup for the PM2005M/P

evaluation module. The three phase voltages are connected

directly to SK1 and each corresponding phase current is wired

through the on-board CT’s.

Figure 3 also shows the default jumper settings. The

PM2005M/P evaluation module is setup by default for

Figure 3: PM2005M/P setup and connection

3x230V/60A operation. For 3x 115V operation jumpers J1, J2

and J3 need to be closed and capacitors C12, C13 and C14

values must be changed to 1µF / 150VAC.

As soon as a load is applied, the pulse LED L7 will start flashing

and the energy counter will increment proportional to the

energy measured.

Load

SK1

N

PH1

PH2

PH3

J1

J2

J3

J7

J6

GND

J5

VSS

J4

VDD

S1

S2

S3

S4

S6

S7

S8

S9

S10

S5