ATA5811 datasheet(2/90 Pages) ATMEL

2 / 90 page

ATA5811/ATA5812 [Preliminary]

4689B–RKE–04/04

General Description

The ATA5811/ATA5812 is a highly integrated UHF ASK/FSK single-channel half-duplex

transceiver with low power consumption supplied in a small QFN48 package. The

receive part is built as a fully integrated low-IF receiver, whereas direct PLL modulation

with the fractional-N synthesizer is used for FSK transmission and switching of the

power amplifier for ASK transmission.

The device supports data rates of 1 kBaud to 20 kBaud (FSK) and 1 kBaud to 10 kBaud

(ASK) in Manchester, Bi-phase and other codes in transparent mode. The ATA5811 can

be used in the 433 MHz to 435 MHz and the 868 MHz to 870 MHz band, the ATA5812

in the 314 MHz to 316 MHz band. The very high system integration level results in few

numbers of external components needed.

Due to its blocking and selectivity performance, together with the additional 15 dB to

20 dB loss and the narrow bandwidth of a typical key fob loop antenna, a bulky blocking

SAW is not needed in the key fob or sensor application. Additionally, the building blocks

needed for a typical RKE and access control system on both sides, the base and the

mobile stations, are fully integrated.

Its digital control logic with self polling and protocol generation enables a fast challenge

response systems without using a high-performance microcontroller. Therefore, the

ATA5811/ATA5812 contains a FIFO buffer RAM and can compose and receive the

physical messages themselves. This provides more time for the microcontroller to carry

out other functions such as calculating crypto algorithms, composing the logical mes-

sages and controlling other devices. Due to that, a standard 4-/8-bit microcontroller

without special periphery and clocked with the CLK output of about 4.5 MHz is sufficient

to control the communication link. This is especially valid for passive entry and access

control systems, where within less than 100 ms several challenge response communi-

cations with arbitration of the communication partner have to be handled.

It is hence possible to design bi-directional RKE and access control systems with a fast

challenge response crypto function with the same PCB board size and with the same

current consumption as uni-directional RKE systems.

Figure 1. System Block Diagram

RF transceiver

Digital Control

Logic

Micorcontroller

Interface

Power Supply

XTO

Microcontroller

ATA5811/ATA5812

Antenna

4 ... 8

Matching

ATA5811 Datasheet(PDF) 2 Page - ATMEL Corporation

ATA5811 Datasheet(HTML) 2 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

Datasheet Download

Link URL