IRMCS2031

procedures are not followed. If you are not familiar with static control procedures, reference applicable ESD

protection handbook and guideline.

ATTENTION: An incorrectly applied or installed drive can result in component damage or

reduction in product life. Wiring or application errors such as undersizing the motor, supplying

an incorrect or inadequate AC supply, or excessive ambient temperatures may result in system

malfunction.

!

ATTENTION: Remove and lock out power from the drive before you disconnect or reconnect

wires or perform service. Wait three minutes after removing power to discharge the bus voltage.

Do not attempt to service the drive until bus voltage has discharged to zero. Failure to do so may

result in bodily injury or death.

!

ATTENTION: The drive is intended to be commanded by control input that will start and stop

the motor. A device that routinely disconnects then reapplies input power to the drive for the

purpose of starting and stopping the motor should not be used. Failure to follow this guideline

may result in damage of equipment, and/or bodily injury or death.

!

ATTENTION: Do not connect power factor correction capacitors to drive output terminals U,

V, and W.

Failure to do so may result in equipment damage or bodily injury.

!

This document is the property of International Rectifier and may not be copied or distributed without expressed consent.

4