AD9273 datasheet(40/49 Pages) AD

40 / 49 page

AD9273

Rev. B | Page 39 of 48

This interface is flexible enough to be controlled by either serial

PROMS or PIC mirocontrollers. This provides the user with

an alternative method, other than a full SPI controller, for

programming the device (see the AN-812 Application Note).

If the user chooses not to use the SPI interface, these pins serve

a dual function and are associated with secondary functions

when the CSB is strapped to AVDD during device power-up.

See the SDIO Pin and SCLK Pin sections for details on which

pin-strappable functions are supported on the SPI pins.

DON’T CARE

SDIO

SCLK

CSB

tDH

tHI

tCLK

tLO

tDS

R/W

A12

A11

A10

Figure 70. Serial Timing Details

Table 16. Serial Timing Definitions

Parameter

Minimum Timing (ns)

Description

tDS

Setup time between the data and the rising edge of SCLK

tDH

Hold time between the data and the rising edge of SCLK

tCLK

Period of the clock

Setup time between CSB and SCLK

Hold time between CSB and SCLK

tHI

Minimum period that SCLK should be in a logic high state

tLO

Minimum period that SCLK should be in a logic low state

tEN_SDIO

Minimum time for the SDIO pin to switch from an input to an output relative to the SCLK

falling edge (not shown in Figure 70)

tDIS_SDIO

Minimum time for the SDIO pin to switch from an output to an input relative to the SCLK

rising edge (not shown in Figure 70)

AD9273 Datasheet(PDF) 40 Page - Analog Devices

AD9273 Datasheet(HTML) 40 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49

Datasheet Download

Link URL