3

Assembly Instruction

Assembly Instructions

1. TRIM CABLE AS SHOWN ABOVE. TIN END OF CENTER CONDUCTOR.

2. SLIDE CRIMP SLEEVE AND SHRINK TUBE (IF SUPPLIED) OVER CABLE JACKET.

3. FLARE CABLE BRAID OUT SLIGHTLY BY ROTATING DIELECTRIC.

4. INSERT CABLE INTO TAIL-END OF BACK NUT, MAKING SURE TAIL GOES OVER

DIELECTRIC AND UNDER BRAID. SLIDE IN UNTIL BRAID TOUCHES REAR SURFACE OF

NUT.

5. SLIDE CRIMP SLEEVE FORWARD AND USE .105 HEX DIE TO CRIMP.

6. POSITION INSULATOR OVER CABLE DIELECTIC AND CENTER CONDUCTOR.

7. SOLDER CONTACT TO CENTER CONDUCTOR.

8. INSERT CAABLE ASSEMBLY INTO BODY AND TIGHTEN NUT WITH A TORQUE WRENCH

WITH A TORQUE OF 35-45 INCH-OUNCES.

9. SLIDE SHRINK TUBE (IF SUPPLIED) OVER CRIMP SLEEVE AND SHRINK TO FIT.

PE45367 REV 1.0

Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,

inventory and certifications: SSMC Plug Connector Crimp/Solder Attachment for RG178, RG196 PE45367

RF Connectors Technical Data Sheet

PE45367

SSMC Plug Connector Crimp/Solder

Attachment for RG178, RG196