MP4030A—PRIMARY-SIDE-CONTROL, OFFLINE, LED CONTROLLER WITH PFC

MP4030A Rev.1.01

www.MonolithicPower.com

12

9/27/2013

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2013 MPS. All Rights Reserved.

Inductor Current

Multiplier Output

Figure 4: Power-Factor Correction

The multiplier’s maximum output voltage to the

current comparator is clamped at 2.3V to limit the

cycle-by-cycle current. The multiplier’s minimum

output voltage is clamped to 0.1V to ensure a

turn-on signal during the TRIAC dimming OFF

interval to pull down the rectifier input voltage for

accurate dimming-phase detection.

reaches 10V, the internal charging circuit stops

charging, the control logic initializes and the

internal main MOSFET begins to switch. Then

the auxiliary winding takes over the power supply.

However, the initial auxiliary-winding positive

the 9V threshold, the internal charging circuit

repeats until the auxiliary winding voltage is high

If any fault occurs during this time, the switching

and the internal charging circuit will stop and

the internal charging circuit re-charges for auto-

restart.

10V

9V

Vcc

Internal

Charging Circuit

and Regulates the V

CC

Auxiliary Winding Takes Charge

Fault Happens

Gate

Switching Pulses

7V

Auto-Start

The MP4030A includes an auto-starter that starts

timing when the MOSFET turns off. If ZCD fails

to send a turn-on signal after 115µs, the auto-

starter

sends

a

turn-on

signal

to

avoid

unnecessary IC shutdowns if ZCD fails.

Minimum OFF Time

The MP4030A operates with a variable switching

frequency and the frequency changes with the

instantaneous input-line voltage. To limit the

maximum

frequency

and

for

good

EMI

performance, the MP4030A employs an internal

minimum OFF-time limiter of 5.1µs, as shown in

Figure 6.

ZCD

GATE

5.1µs