PD100F5 datasheet(5/8 Pages) NIEC

5 / 8 page

Certain Kyocera displays require a +3 volt vee voltage. These

displays will use the PC8106N-2 Rev E or higher. DO NOT use

PC8106P or any earlier version of the PC8106N board. Contrast

on these displays are adjusted with R23, 5K potentiometer.

Windows 3.1 Driver Installation ...

The Windows 3.1 driver is for CDS PC8106, VGA104 256 color

driver board only. To check if you have a 256 color version the

part number on the LCD controller should read: “SPC8106FOC”.

To install driver:

1. Locate your original Windows 3.1 disks, you will need them

to load the required fonts.

2. Go to your Windows subdirectory: “CD WINDOWS”.

3. Run Windows setup program: “SETUP”.

4. Select “Display” and press enter.

5. Scroll down to the end of the list and select:

“Other (Requires disk provided by hardware manufacturer)”.

6. Insert the driver disk and press enter.

7. Follow instructions to finish installation.

8. After the driver has loaded select “Accept configuration

shown above” and press enter.

9. Follow the instructions, it will ask you to insert several

of your original Windows 3.1 disks and close.

NOTES:

A. For color displays you must install this driver for the 256

color mode. If the 16 color mode is acceptable for your

application you do not have to install this driver, select

the Windows 3.1 standard VGA or VGA 3.0 driver.

B. For monochrome displays there is no need to load the 256

color driver. Select Windows 3.1 standard VGA or VGA 3.0

driver.

C. For Windows 95 applications please consult the sales office.

PD100F5 Datasheet(PDF) 5 Page - Nihon Inter Electronics Corporation