MSM9810 datasheet(12/32 Pages) OKI

12 / 32 page

12/31

¡ Semiconductor

MSM9810

Channel 1

Channel 2

Channel 3

fS=16.0kHz

fS=32.0kHz (Valid)

fS=25.6 kHz (Invalid, playback with fS=32.0 kHz)

Figure 3.1 When channel 3 is played back using a different sampling frequency

while channel 1 and 2 are being played back.

Channel 1

Channel 2

fS=16.0kHz

fS=25.6kHz (Valid)

Channel 1 ends

Figure 3.2 Channel 2 is played back using different sampling frequency

after channel 1 was played back

3. Sampling Frequency

Sampling frequency can be specified for each phrase in the address management area of external

ROM. For the sampling frequency, the following ten types can be selected when voice data is

created.

4.0 kHz, 8.0 kHz, 16.0 kHz, 32.0 kHz

(Group 1)

5.3 kHz, 10.6 kHz, 21.3 kHz

(Group 2)

6.4 kHz, 12.8 kHz, 25.6 kHz

(Group 3)

3-1 Channel Synthesis

When the internal LPFs are used, use of a different sampling frequency than the selected

sampling frequency GroupX is not permitted for channel synthesis.

The internal LPF can be used by selecting "use of internal LPF" with the OPT command (see 9-

4 "OPT Command").

When the internal LPFs are not used, channel synthesis can be made using a different sampling

frequency as shown below.

When channels are synthesized, the sampling frequency Group of the first vocalizing channel

(one of the above Group 1 to 3) is selected. If the sampling frequency Group other than the

selected Group is used for channel synthesis, playback becomes fast or slow. Figure 3.1 and

Figure 3.2 show examples.

MSM9810 Datasheet(PDF) 12 Page - OKI electronic componets