23

TMCS1100

www.ti.com

SBOS820 – SEPTEMBER 2019

Product Folder Links: TMCS1100

Submit Documentation Feedback

Copyright © 2019, Texas Instruments Incorporated

10.2 Typical Application

Inline sensing of motor phase current provides significant benefits to the performance of a motor control system,

allowing advanced control algorithms and diagnostics with minimal postprocessing. A primary challenge to inline

sensing for motor drives is that the current sensor is subjected to full HV supply-level PWM transients driving the

motor phase. The inherent isolation of an in-package Hall-effect current sensor topology helps overcome this

challenge, providing high common-mode immunity, as well as isolation between the high-voltage motor drive

levels and the low-voltage control circuitry. Figure 12 illustrates the use of the TMCS1100 in such an application.

Figure 12. Inline Motor Phase Current Sensing

10.2.1 Design Requirements

For current sensing of a three-phase motor application, make sure to provide linear sensing across the expected

current range, and make sure that the device remains within working thermal constraints. A single TMCS1100 for

each phase can be used, or two phases can be measured, and the third phase calculated on the motor-controller

host processor. For this example, consider a nominal supply of 5 V but a minimum of 4.9 V to include for some

supply variation. Maximum output swings are defined according to TMCS1100 specifications, and a full-scale

current measurement of ±20 A is required.

Table 2. Example Application Design Requirements

DESIGN PARAMETER

EXAMPLE VALUE

5 V

4.9 V

±20 A