| Electronic Components Datasheet Search |
|
AH1014 Datasheet(PDF) 40 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
AH1014 Datasheet(HTML) 40 Page - NXP Semiconductors |
|
40 / 121 page ![]() NXP Semiconductors AH1014 Systems & Applications, Automotive Innovation Center AH1014_v1.4_Application Hints TJA1042_43_48_51.doc © NXP B.V. 2015. All rights reserved. Rev. 01.40 — 27 April 2015 40 of 121 5.4.3 Undervoltage detection & recovery The TJA1048 provides two supply pins, VCC and VIO. The VCC voltage is needed for the CAN physical interface. VCC provides the current needed for the CAN transmitter and receiver in Normal Mode. Pin VIO should be connected to the microcontroller supply voltage. This will adjust the signal levels of pins TXD1, TXD2, RXD1, RXD2, STBN1 and STBN2 to the I/O levels of the microcontroller. Pin VIO also provides the internal supply voltage for the low power differential receiver of each integrated transceivers. For applications running in low power, this allows the bus lines to be monitored for activity even if there is no supply voltage on pin VCC. Both voltages are independent from each other. An undervoltage detection circuitry at VCC and VIO indicates either a VCC or VIO undervoltage condition that is used for mode control. A VCC undervoltage condition forces both CAN channels of the TJA1048 to enter Standby Mode. The logic state of pins STBN1 and STBN2 will be ignored until VCC has recovered. This allows saving current in case of switching off the supply voltage or faulty behaviour of host electronic control unit. As long as VIO keeps present the TJA1048 offers the full wake- up capability. A VIO undervoltage condition forces both CAN channels of the TJA1048 to switch off (OFF Mode) and to disengages from the bus (zero load) until VIO has recovered. In OFF Mode both CAN transceiver behave passive to the bus. Table 6 gives an overview of the undervoltage behaviour. As long as no undervoltage is detected the TJA1048 keeps fully operational. Table 6. Device behaviour in different power conditions Undervoltage condition Operating mode CAN1 / CAN2 biasing Bus wake-up capability VCC VIO no no Normal or Standby VCC/2 or GND yes yes no Standby GND yes no yes OFF float no yes yes OFF float no |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |