TLV840 datasheet(13/29 Pages) TI

13 / 29 page

8.3.2 User-Programmable Reset Time Delay

The reset time delay can be set to a minimum value of 80 µs by leaving the CT pin floating, or a maximum value

of approximately 6.2 seconds by connecting 10 µF delay capacitor. The reset time delay (t D) can be

programmed by connecting a capacitor no larger than 10 µF between CT pin and GND.

The relationship between external capacitor (CCT) in µF at CT pin and the time delay (tD) in seconds is given by

Equation 2.

tD = -ln (0.29) x RCT x CCT + tD (CT pin = Open)

(2)

Equation 3 solves for external capacitor (μF) by plugging R CT and t D (CT pin = Open) given in Section 7.5

section:

CCT = (tD- 80 µs) ÷ 618937

(3)

The recommended maximum delay capacitor for the TLV840-Q1 is limited to 10 µF as this ensures there is

enough time for the capacitor to fully discharge when the reset condition occurs. When a voltage fault occurs,

the previously charged up capacitor discharges, and if the monitored voltage returns from the fault condition

before the delay capacitor discharges completely, the reset delay will be shorter than expected because the

delay capacitor will begin charging from a voltage above zero. Larger delay capacitors can be used so long as

the capacitor has enough time to fully discharge during the duration of the voltage fault. The amount of time

required to discharge the delay capacitor relative to the reset delay increases as VDD overdrive increases as

shown in Figure 8-3.

VDD Fault Underoltage (V)

0.6

0.8

1.2

1.4

1.6

1.8

CTR_

25°C

Figure 8-3. CCT Discharge Time During Fault Condition (VIT- = 2.1 V, CCT = 1 µF)

www.ti.com

TLV840-Q1

SNVSBY3 – NOVEMBER 2020

Submit Document Feedback

Product Folder Links: TLV840-Q1

TLV840 Datasheet(PDF) 13 Page - Texas Instruments