1. Introduction

This document contains the information for the IoT Bit (version number). It describes the process,

safety information and different components for the IoT Bit kit.

1.1 Safety Information

Do not expose to water or high moisture environments.

The board should be placed on a flat, stable, non-conductive surface.

Minimize the handling of the board when connected.

Do not operate the device next to flammable gases or fumes.

Do not operate in any kind of aircraft. Make sure device is switched off for flight duration.

RF interference can occur if it is used next to a TV, radios, computers or other electronic equipment.

Do not operate in environments where the network is restricted such as hospitals or emergency call centres.

The incorrect connection of the 40-header pin may result in damage to the device.

Do not place next to a heat source.

1.2 Legal Information

Do not use these products for any illegal activities.

Warranty and legal documentation is available to view at:

Altitude.tech/altitude-tech-terms-and-conditions/

COPYRIGHT

THE INFORMATION CONTAINED HERE IS PROPRIETARY TECHNICAL INFORMATION OF ALTERED

CARBON LTD. TRANSMITTING, REPRODUCTION, DISSEMINATION AND EDITING OF THIS DOCUMENT

AS WELL AS UTILIZATION OF THE CONTENT ARE FORBIDDEN WITHOUT PERMISSION. OFFENDERS WILL

BE HELD LIABLE FOR PAYMENT OF DAMAGES. ALL RIGHTS ARE RESERVED IN THE EVENT OF A PATENT

GRANT OR REGISTRATION OF A UTILITY MODEL OR DESIGN.

5