4707 Dey Road Liverpool, N.Y. 13088

(315) 701-6751

M.S.KENNEDY CORP.

ISO 9001 CERTIFIED BY DSCC

4363

10 AMP, 75V, 3 PHASE

MOSFET BRUSHLESS

MOTOR CONTROLLER

FEATURES:

75 Volt Motor Supply Voltage

10 Amp Output Switch Capability

100% Duty Cycle High Side Conduction Capable

Shoot-Through/Cross Conduction Protection

Hall Sensing and Commutation Circuitry on Board

"Real" Four Quadrant Torque Control Capability

Good Accuracy Around the Null Torque Point

Isolated Base Plate Design for High Voltage Isolation Plus Good Thermal Transfer

60°/ 120º Phasing Selectable

MIL-PRF-38534 QUALIFIED

DESCRIPTION:

The MSK 4363 is a complete 3 Phase MOSFET Bridge Brushless Motor Control System in an electrically isolated

hermetic package. The hybrid is capable of 10 amps of output current and 75 volts of DC bus voltage. It has the

normal features for protecting the bridge. Included is all the bridge drive circuitry, hall sensing circuitry, commutation

circuitry and all the current sensing and analog circuitry necessary for closed loop current mode (torque) control.

When PWM'ing, the transistors are modulated in locked anti-phase mode for the tightest control and the most

bandwidth. Provisions for applying different compensation schemes are included. The MSK 4363 has good thermal

conductivity of the MOSFET's due to isolated substrate/package design that allows direct heat sinking of the hybrid

without insulators.

EQUIVALENT SCHEMATIC

TYPICAL APPLICATIONS

3 Phase Brushless DC Motor Control

Servo Control

Fin Actuator Control

1

Rev. G 8/01

Gimbal Control

AZ-EL Control