LPC43S20 datasheet(71/156 Pages) NXP

71 / 156 page

LPC43S50_S30_S20

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 1.3 — 20 January 2020

71 of 156

NXP Semiconductors

LPC43S50/S30/S20

32-bit ARM Cortex-M4/M0 microcontroller

• 16 DMA request lines.

• Single DMA and burst DMA request signals. Each peripheral connected to the DMA

Controller can assert either a burst DMA request or a single DMA request. The DMA

burst size is set by programming the DMA Controller.

• Memory-to-memory, memory-to-peripheral, peripheral-to-memory, and

peripheral-to-peripheral transfers are supported.

• Scatter or gather DMA is supported through the use of linked lists. This means that

the source and destination areas do not have to occupy contiguous areas of memory.

• Hardware DMA channel priority.

• AHB slave DMA programming interface. The DMA Controller is programmed by

writing to the DMA control registers over the AHB slave interface.

• Two AHB bus masters for transferring data. These interfaces transfer data when a

DMA request goes active. Master 1 can access memories and peripherals, master 0

can access memories only.

• 32-bit AHB master bus width.

• Incrementing or non-incrementing addressing for source and destination.

• Programmable DMA burst size. The DMA burst size can be programmed to more

efficiently transfer data.

• Internal four-word FIFO per channel.

• Supports 8, 16, and 32-bit wide transactions.

• Big-endian and little-endian support. The DMA Controller defaults to little-endian

mode on reset.

• An interrupt to the processor can be generated on a DMA completion or when a DMA

error has occurred.

• Raw interrupt status. The DMA error and DMA count raw interrupt status can be read

prior to masking.

7.17.3 SPI Flash Interface (SPIFI)

The SPI Flash Interface allows low-cost serial flash memories to be connected to the ARM

Cortex-M4 processor with little performance penalty compared to parallel flash devices

with higher pin count.

After a few commands configure the interface at startup, the entire flash content is

accessible as normal memory using byte, halfword, and word accesses by the processor

and/or DMA channels. Simple sequences of commands handle erasing and

programming.

Many serial flash devices use a half-duplex command-driven SPI protocol for device setup

and initialization and then move to a half-duplex, command-driven 4-bit protocol for

normal operation. Different serial flash vendors and devices accept or require different

commands and command formats. SPIFI provides sufficient flexibility to be compatible

with common flash devices and includes extensions to help insure compatibility with future

devices.

7.17.3.1 Features

• Interfaces to serial flash memory in the main memory map.

LPC43S20 Datasheet(PDF) 71 Page - NXP Semiconductors

LPC43S20 Datasheet(HTML) 71 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL