114-94667

21 of 29

Figure 22: Notes regarding recommended panel/enclosure geometry for 2339729-X.

Figure 23: Recommended screw for installation for 2339729-X.

7.12

Mating of Plug and Corresponding Assembly

i.

Align the assembled Plug and corresponding connectors face to face with the key slots

and latch features aligned. Then, push the connec

tors together, until hearing a “click”

sound. Refer to Figure 24.

ii.

Push the CPA forward until there is an audible and tactile “click”; which mates and locks

the connectors together. See Figure 24.

iii.

The CPA lock should be easy to engage. It will be difficult to engage if the connector and

mating connector are not fully mated.

CAUTION

For wire to device application, the interface on the device must meet requirements shown on

interface drawing. Interface drawings described in Figure 1.

CAUTION

To prevent damage to the CPA lock or connector, DO NOT force the CPA lock to engage.