114-94667

12 of 29

7.7

Assembly Procedure for Cap

A. Terminal Insertion for Cap

i. Ensure that the terminals are properly crimped. Refer to Application Specification 114-94413

for crimping requirements.

ii. Make sure that the TPA is in Pre-lock condition as shown in Figure 8, Detail A.

iii. Insert the terminal into the circuit cavity until it bottoms. There should be an audible or tactile

“click” when the terminal is fully seated. Gently pull the wire to ensure that the terminal is locked

in place.

iv. After the terminals are assembled, push the TPA on the 2/4 side of the TPA with a small

screwdriver or TE extraction tool

into final lock position until hear the “click” sound as shown

in Figure 8 Detail C.

Caution: Care must be taken to ensure the sealing surface is not scratched while mating

the TPA.

Caution: Care must be taken to ensure terminals are not damaged when mating the TPA.

Figure 7