CS1311 datasheet(15/25 Pages) NSC

15 / 25 page

Revision 2.2

www.national.com

Signal Definitions (Continued)

2.2.3

PCI Interface Signals

Signal Name

Ball

No.

Type

Description

PCI_CLK

PCI Clock. All PCI input signals are sampled with respect to the rising

edge of this clock. All PCI outputs are generated based on this clock.

This clock is required for normal operation of the PCI module.

PCI_AD[31:00]

See Table

2-3 on

page 12

I/O

Multiplexed Address and Data.

PCI_C/BE0#

I/O

Multiplexed Bus Commands and Byte-Enables. High for command,

low for byte-enable.

PCI_C/BE1#

PCI_C/BE2#

PCI_C/BE3#

PCI_PAR

I/O

Parity. Even parity across AD and C/BE# lines.

PCI_FRAME#

I/O

Frame Sustained TRI-STATE. Frame isdrivenbyamaster to indicate

the beginning and duration of an access.

PCI_IRDY#

I/O

Initiator Ready Sustained TRI-STATE. Initiator Ready indicates that

the bus master is ready to complete the current data phase.

PCI_TRDY#

I/O

Target Ready Sustained TRI-STATE. Target Ready indicates that the

bus target is ready to complete the current data phase.

PCI_STOP#

I/O

Stop Sustained TRI-STATE. Indicates that the target is requesting that

the master stop the current transaction.

PCI_IDSEL

ID Select. Used as chip select during configuration read/write cycles.

PCI_DEVSEL#

I/O

Device Select Sustained TRI-STATE. Indicates whether any device on

the bus has been selected.

PCI_REQ#

Request. Driven by the CS1301/CS1311 as a PCI bus master to request

use of the PCI bus.

PCI_GNT#

Grant. Indicates to the CS1301/CS1311 that access to the PCI bus has

been granted.

PCI_PERR#

I/O

Parity Error Sustained TRI-STATE. Parity error generated/received by

CS1301/CS1311.

PCI_SERR#

System Error. This signal is asserted when operating as a target and

detecting an address parity error.

PCI_INTA#

I/OD

PCIInterruptsA,B, C,and D. Can operate as an input (power-up

default) or output, as determined by direction control bits in PCI MMIO

As an input, PCI_INT# can be used to receive PCI interrupt requests

(normal PCI use is active low, level-sensitive mode, but the VIC can be

set to treat these as a positive edge triggered mode). As an input,

PCI_INT# can also be used as a general interrupt request if not needed

for PCI.

As an output, the value of a PCI_INT# can be programmed through PCI

MMIO registers to generate interrupts for other PCI masters.

PCI_INTB#

I/O/OD

PCI_INTC#

I/OD

PCI_INTD#

I/OD

Note:

Current buffer design allows drive/receive from either 3.3V or 5.0V PCI bus.

CS1311 Datasheet(PDF) 15 Page - National Semiconductor (TI)

CS1311 Datasheet(HTML) 15 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Datasheet Download

Link URL