Type 8098

13 | 40

Visit product website 

Data transfer

• Device without output: external communication through büS (Bürkert system bus, CANopen

protocol)

• Device with 2 outputs: büS connection only to the Bürkert Communicator for configuration and

software update of the device. Due to the missing CAN shield the conventional büS/ CANopen

communication is not recommended.

Environment and installation

Ambient temperature

Operation:

• All variants except ATEX/IECEx variant:

– - 10…+ 70 °C (+ 14…+ 158 °F) if - 20 °C (4 °F) ≤ fluid temperature ≤ 80 °C (176 °F)

– at a fluid temperature > 80 °C (176 °F), the maximum ambient temperature decreases linearly

from 70 °C (158 °F) up to 40 °C (104 °F).

This means that at a fluid temperature of 80 °C (176 °F) the ambient temperature may be a maxi-

mum of 70 °C (158 °F) and at a fluid temperature of 140 °C (284 °F) the ambient temperature

may only be a maximum of 40 °C (104 °F).

• ATEX/IECEx variant:

– - 10…+ 60 °C (+ 14…+ 140 °F) if - 20 °C (4 °F) ≤ fluid temperature ≤ 100 °C (212 °F)

– at a fluid temperature > 100 °C (212 °F), the maximum ambient temperature decreases linearly

from 60 °C (140 °F) up to 45 °C (136 °F).

This means that at a fluid temperature of 100 °C (212 °F) the ambient temperature may be a

maximum of 60 °C (140 °F) and at a fluid temperature of 130 °C (266 °F) the ambient temperature

may only be a maximum of 45 °C (136 °F)

Further information can be found in chapter “5.1. Medium temperature diagram” on page 24.

1.) Only if option density measurement and mass flow rate measurement is activated

2.

Approvals and conformities

2.1. General notes

• The approvals and conformities listed below must be stated when making enquiries. This is the only way to ensure that the product

complies with all required specifications.

• Not all available variants of the device can be supplied with the below mentioned approvals or conformities.

2.2. Conformity

In accordance with the Declaration of Conformity, the product is compliant with the EU Directives.

2.3. Standards

The applied standards which are used to demonstrate compliance with the EU Directives are listed in the EU-Type Examination Certificate

and/or the EU Declaration of Conformity.