Type 8741

5 | 24

Visit product website 

Accessories

Software

Bürkert Communicator

Detailed information can be found in chapter “8.1. Bürkert Communicator software”

on page 22.

1.) For a detailed description of LED colours see operating instructions Type 8741 

2.) If the operating medium is different from the calibration medium, the actual measurement accuracy might vary from the indicated value. If the operating medium is natural gas, the

measurement accuracy depends on the composition of the natural gas, which can vary depending on the origin and season.

3.) Information in relation to the typical power consumption (at + 23 °C ambient temperature, nominal flow and 30 min closed-loop control mode). Information according to UL 61010 - 1

may vary (see operating instructions Type 8741 ).

4.) An additional digital input and a relay output are available for the analogue variant with D-Sub 9.

5.) Supply voltage via separate terminal block

2.

Approvals and conformities

2.1. General notes

Note:

• The approvals and conformities listed below must be stated when making enquiries. This is the only way to ensure that the product

complies with all required specifications.

• Not all available variants can be supplied with the below mentioned approvals or conformities.

2.2. Conformity

In accordance with the Declaration of Conformity, the product is compliant with the EU Directives.

2.3. Standards

The applied standards which are used to demonstrate compliance with the EU Directives are listed in the EU-Type Examination Certificate

and/or the EU Declaration of Conformity.

2.4. North America (USA/Canada)

Approval

Description

Optional: UL Listed for the USA and Canada

The products are UL Listed for the USA and Canada according to:

• UL 61010-1 (ELECTRICAL EQUIPMENT FOR MEASUREMENT, CONTROL, AND LABORATORY USE –

Part 1: General Requirements)

• CAN/CSA-C22.2 No. 61010-1

2.5. Foods and beverages/Hygiene

Conformity

Description

FDA

FDA – Code of Federal Regulations (valid for variable code PL02, PL03)

All wetted materials are compliant with the Code of Federal Regulations published by the FDA (Food and Drug

Administration, USA) according to the manufacturer‘s declaration.

USP

United States Pharmacopeial Convention (USP) (valid for variable code PL04)

All wetted materials are biocompatible according to the manufacturer‘s declaration.

EC Regulation 1935/2004 of the European Parliament and of the Council (valid for variable code PL01, PL02)

All wetted materials are compliant with EC Regulation 1935/2004/EC according to the manufacturer‘s declaration.