Type 8077

4 | 7

Visit product website 

Approvals and conformities

Directives

CE directive

Further information on the CE Directive can be found in chapter “2.2. Standards” on page 4

Pressure equipment directive

Complying with article 4, paragraph 1 of 2014/68/EU directive

Further information on the pressure equipment directive can be found in chapter “2.3. Pressure

Equipment Directive (PED)” on page 4.

Environment and installation

Ambient temperature

Operation and storage: - 15…+ 60 °C (+ 5…+ 140 °F)

Relative air humidity

≤ 85 %, without condensation

Height above sea level

Max. 2000 m

Operating condition

Continuous

Device mobility

Fixed

Application range

Indoor and outdoor

Protect the device against electromagnetic interference, ultraviolet rays and, when installed outdoors,

against the effects of climatic conditions.

Degree of protection

IP67, IP66 according to IEC/EN 60529, NEMA 6 according to NEMA 250

Installation category

Category I according to UL/EN 61010-1

Pollution degree

Degree 2 according to UL/EN 61010-1

2.

Approvals and conformities

2.1. Conformity

In accordance with the Declaration of Conformity, the product is compliant with the EU Directives.

2.2. Standards

The applied standards which are used to demonstrate compliance with the EU Directives are listed in the EU-Type Examination Certificate

and/or the EU Declaration of Conformity.

2.3. Pressure Equipment Directive (PED)

The device conforms to article 4, paragraph 1 of the Pressure Equipment Directive (PED) 2014/68/EU under the following conditions:

Device used on a pipe

Note:

• The data in the table is independent of the chemical compatibility of the material and the fluid.

• PS = maximum admissible pressure (in bar), DN = nominal diameter of the pipe

Type of fluid

Conditions

Fluid group 1, article 4, paragraph 1.c.i

DN ≤ 25

Fluid group 2, article 4, paragraph 1.c.i

DN ≤ 32 or PS*DN ≤ 1000

Fluid group 1, article 4, paragraph 1.c.ii

DN ≤ 25 or PS*DN ≤ 2000

Fluid group 2, article 4, paragraph 1.c.ii

DN ≤ 200 or PS ≤ 10 or PS*DN ≤ 5000