33993 datasheet(10/28 Pages) FREESCALE

10 / 28 page

Analog Integrated Circuit Device Data

Freescale Semiconductor

33993

FUNCTIONAL DESCRIPTION

FUNCTIONAL PIN DESCRIPTION

WAKE-UP (WAKE)

The WAKE pin is an open-drain output and a wake-up

input. The pin is designed to control a power supply Enable

pin. In the Normal mode, the WAKE pin is low. In the Sleep

mode, the WAKE pin is high. The WAKE pin has a pull-up to

the internal +5.0 V supply.

In Sleep mode with the WAKE pin high, falling edge of

WAKE will place the 33993 in Normal mode. In Sleep mode

with VDD applied, the INT pin must be high for negative edge

of WAKE to wake up the device. If VDD is not applied to the

device in Sleep mode, INT does not affect the WAKE

operation.

BATTERY INPUT (VPWR)

The VPWR pin is battery input and Power-ON Reset to the

33993 IC. The VPWR pin requires external reverse battery

and transient protection. Maximum input voltage on VPWR is

50 V. All wetting, sustain, and internal logic current is

provided from the VPWR pin.

VOLTAGE DRAIN SUPPLY (VDD)

The VDD input pin is used to determine logic levels on the

microprocessor interface (SPI) pins. Current from VDD is

used to drive SO output and the pull-up current for CS and

INT pins. VDD must be applied for wake-up from negative

edge of CS or INT.

GROUND (GND)

The GND pin provides ground for the IC as well as ground

for inputs programmed as switch-to-battery inputs.

PROGRAMMABLE SWITCHES 0–7 (SP0–SP7)

The 33993 device has 8 switch inputs capable of being

programmed to read switch-to-ground or switch-to-battery

contacts. The input is compared with a 4.0 V reference.

When programmed to be switch-to-battery, voltages greater

than 4.0 V are considered closed. Voltages less than 4.0 V

are considered open. The opposite holds true when inputs

are programmed as switch-to-ground. Programming features

are defined in Table 5 through Table 10 in the Logic

Commands and Registers section of this datasheet. Voltages

greater than the VPWR supply voltage will source current

through the SP inputs to the VPWR pin. Transient battery

voltages greater than 40 V must be clamped by an external

device.

SWITCH-TO-GROUND INPUTS 0–13 (SG0–SG13)

The SGn pins are switch-to-ground inputs only. The input

is compared with a 4.0 V reference. Voltages greater than

4.0 V are considered open. Voltages less than 4.0 V are

considered closed. Programming features are defined in

Table 5 through Table 10 in the Logic Commands and

Registers section of this datasheet. Voltages greater than the

VPWR supply voltage will source current through the SG

inputs to the VPWR pin. Transient battery voltages greater

than 40 V must be clamped by an external device.

33993 Datasheet(PDF) 10 Page - Freescale Semiconductor, Inc

33993 Datasheet(HTML) 10 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Datasheet Download

Link URL