| Electronic Components Datasheet Search |
|
SN74HCS240 Datasheet(PDF) 8 Page - Texas Instruments |
|
|
|
|||||||||||||||||||||||||||||
SN74HCS240 Datasheet(HTML) 8 Page - Texas Instruments |
|
8 / 31 page ![]() 7 Detailed Description 7.1 Overview The SN74HCS240 contains 8 individual high speed CMOS inverters with Schmitt-trigger inputs and 3-state outputs. Each inverter performs the boolean logic function xYn = xAn, with x being the bank number and n being the channel number. Each output enable (xOE) controls four inverters. When the xOE pin is in the low state, the outputs of all inverters in the bank x are enabled. When the xOE pin is in the high state, the outputs of all inverters in the bank x are disabled. All disabled output are placed into the high-impedance state. To ensure the high-impedance state during power up or power down, both OE pins should be tied to VCC through a pull-up resistor; the minimum value of the resistor is determined by the current sinking capability of the driver and the leakage of the pin as defined in the Electrical Characteristics table. 7.2 Functional Block Diagram Figure 7-1. Logic Diagram (Positive Logic) for SN74HCS240 7.3 Feature Description 7.3.1 Feature Description The SNx4HC132 has a wide operating range of 2 V to 6 V. The SNx4HC132 also has a low power consumption where the maximum ICC is 20 µA. 7.3.1.1 Balanced CMOS 3-State Outputs This device includes balanced CMOS 3-state outputs. Driving high, driving low, and high impedance are the three states that these outputs can be in. The term balanced indicates that the device can sink and source similar currents. The drive capability of this device may create fast edges into light loads, so routing and load conditions should be considered to prevent ringing. Additionally, the outputs of this device can drive larger currents than the device can sustain without being damaged. It is important for the output power of the device to be limited to avoid damage due to overcurrent. The electrical and thermal limits defined in the Absolute Maximum Ratings must be followed at all times. When placed into the high-impedance state, the output will neither source nor sink current, with the exception of minor leakage current as defined in the Electrical Characteristics table. In the high-impedance state, the output voltage is not controlled by the device and is dependent on external factors. If no other drivers are connected to the node, then this is known as a floating node and the voltage is unknown. A pull-up or pull-down resistor can be connected to the output to provide a known voltage at the output while it is in the high-impedance state. SN74HCS240 SCLS871B – JULY 2021 – REVISED AUGUST 2024 www.ti.com 8 Submit Document Feedback Copyright © 2024 Texas Instruments Incorporated Product Folder Links: SN74HCS240 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |