6

© 2006 Semtech Corp.

www.semtech.com

POWER MANAGEMENT

SC488

Notes:

1) Only available in tape and reel packaging. A reel contains 3000 devices.

2) This product is fully WEEE and RoHS compliant.

Pin #

Pin Name

Pin Function

1

PGND2

Power ground for VTT output. Connect to thermal pad and ground plane.

2

VTTS

Sense pin for VTT. Connect to VTT at the load.

3

VSSA

Ground reference for analog circuitry. Connect to thermal pad.

4TON

This pin is used to sense VBAT through a pull-up resistor, RTON, which sets the top MOSFET

on-time. Bypass this pin with a 1nF capacitor to VSSA.

5

REF

Reference output. An internal resistor divider from VDDQS sets this voltage to 50% VDDQ (nomi-

nal). Bypass this pin with a series 10

Ω/1μF to VSSA.

6

VCCA

Analog supply voltage input. Use a 10

Ω/1μF RC filter from +5V to VSSA.

7

NC

No connect.

8

VDDQS

Sense input for VDDQ. Used to set the on-time for the top MOSFET and also to set REF/VTT.

9

FB

Feedback select input for VDDQ. See FB Configuration Table.

10

VTTEN

Enable pin for VTT. Pull this pin low to disable VTT (REF remains present as long as VDDQ is

present).

11

EN/PSV

Enable/Power Save input pin. Tie to ground to disable VDDQ. Tie to +5V to enable VDDQ and

activate PSAVE mode. Float to enable VDDQ and activate continous conduction mode. If floated,

bypass to VSSA with a 10nF capacitor.

12

NC

No connect.

13

PGD

Power good output for VDDQ. PGD is low if VDDQ is outside the power good thresholds. This

pin is an open drain NMOS output and requires an external pull-up resistor.

SC488MLTRT

MLPQ-24

Pin Description

Pin Configuration

Ordering Information

PGND1

ILIM

PGND1

PGD

VDDP

VDDP

PGND2

VSSA

VTTS

VCCA

TON

REF

2

1

4

3

6

5

17

18

15

16

13

14

SC480 MLP24 Pin Out

T

SC488