MFR-1100 Series

60W Single Output Solder / Rework System

MFR-1100: 5 Handpiece Options:

There Is A System That’s Right For You

Metcal's MFR-1100 Soldering Systems are powerful,

cost-effective systems with a wide variety of options and

accessories to meet just about any application. The MFR-

1100 power supply has a powerful 60W output, and a wide

variety of cartridges and tips are available so your operators

can complete just about any task. 5 hand-pieces are available,

including a desoldering option, so the MFR-1100 can meet just

about any need.

The MFR-1100 series uses SmartHeat® Technology, a

microprocessor controlled heating system which operates at lower

temperatures and eliminates calibration time. With soldering and

desoldering capabilities, the MFR-1100 eliminates the need for two

separate units.

The MFR-1100 series is your best choice for a versatile soldering

system with a small footprint.

MFR-1100 Series Features and Benefits

• Many options enable you to create the system you need

• 60W output gives you the power you need while using lower

and safer temperatures.

• SmartHeat® tips and cartridges sense the load and instantly

delivers the right amount of heat to the joint.

• No calibration required which saves money and down-time.

www.metcal.com

Technical Specifications

Pg 1

Power Supply Part No.

MFR-PS1100

Ambient Operating Temp.

10 - 40°C (50 - 104°F)

Max. Enclosure Temp.

55°C (131°F)

Input Line Voltage

100 - 240 VAC

Power Consumption

70W Max.

Input Line Frequency

50/60 Hz grounded circuit

Output Power

60W @ 22°C/output*

Output Frequency

450 KHz

Power Cord (3-wire)

183cm (6’), 18/3 SJT

Dimensions (approx.) W x D x H

90 x 142 x 197.5mm (3.5” x 5.6” x 7.8”)

Weight

2.3 kg (5.05 lbs)

Surface Resistivity

105- 109 Ohms

Certification / Marking

cTUVus, CE

Soldering Handle and Coil Assembly Specifications

Tip-to-Ground Potential

< 2 mV RMS

Tip-to-Ground Resistance

<2 ohms

Idle Temperature Repeatability

± 1.1°C (2°F) in still air

Handle Cord Assembly Length

122cm (4’) – burn proof, ESD safe

Connector

8-pin circular DIN

Workstand W x D x H

100 x 200 x 100mm (4” x 8” x 4”)

Workstand Weight

0.69 kg (1.51 lbs)

* RF SmartHeat Technology provides greater power. More details

at www.metcal.com

5 Hand-piece Options

Solder Cartridge Hand-piece (MFR-H1-SC2)

Standard equipment with MFR-1110/1161

Tip Solder Hand-piece (MFR-H2-ST2)

Standard equipment with MFR-1120

SSC Cartridge Solder Hand-piece (MFR-H6-SSC)

Standard equipment with MFR-1160/1161

Precision Tweezer Solder

Hand-piece (MFR-H4-TW).

Standard equipment with

MFR-1140

Desolder Hand-piece

(MFR-H5-DS).

Available as an

accessory; see page 3