Multichannel detector head controller

C7557

s Operation method

1. Make connections as indicated in ➀ to ➄.

➀ LINE

Connect to the power cable.

Connect to a computer through the SCSI interface cable. When C7557 is the last unit in the SCSI

chain, plug a teminator into another SCSI port on C7557.

➂ TE CONTROL I/O

Connect to the "TE CONTROL I/O" terminal on the detector head.

➃ SIGNAL I/O

Connect to the "I/O SIGNAL" terminal on the detector head.

➄ GND

When a 2-pin AC plug is used with the power cable, use this GND connector to ground the unit.

2. When all the connections are complete, turn on the power to C7557.

3. Install the dedicated softeware. (For details on the dedicated software, refer to the operation manual supplied in the package.)

*4: A terminator must be plugged into the last unit in the SCSI chain.

KACCC0083EC

FRONT VIEW

LINE

SCSI ID

RS-232C

SCSI

SYNC.OUT

VIDEO OUT

PULSE OUT

TRIG.IN

REAR VIEW

POWER

TE CONTROL I/O

SIGNAL I/O

3