SmartBond TINY Bluetooth® LE Module

R18DS0047EE0340 Revision 3.4

Sept 20, 2024

CFR0011-120-00

Page 28

12.5 NCC (Taiwan)

Model no. DA14531MOD-00F0100

NCC ID: CCAG20LP0160T6

The DA14531 TINYTM Module has received compliance approval in accordance with the Telecommunications

Act. The module has been tested according to following standard:

▪ Radio: Low Power Radio Frequency Devices Technical Regulations (LP0002)

The end product may need to follow additional requirement according to regulation EMC.

注意！

取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計

之特性及功能。低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，

並改善至無干擾時方得繼續使用。前述合法通信，指依電信管理法規定作業之無線電通信。低功率射頻器材須忍

受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。

End-product labelling

The NCC ID can be applied directly on the end-product's label.

12.6 KC (South Korea)

Model no. DA14531MOD-00F0100

MSIP ID: R-R-Dlg-DA14531MOD

R-R-Dlg-DA14531MOD

DA14531 TINYTM Module has received certification of conformity in accordance with Radio Waves Act. The

module has been tested according to following standard:

▪ Radio: Ministry of Science and ICT Notice No. 2019-105

For the end-product wireless test, you can refer to Renesas's own certification report so that the lab knows the

module itself has passed although it still needs to be tested.

Additionally, EMC for wireless (KN301489).

End-product labelling

The MSIP ID can be applied directly on the end-product's label. The ID should be clearly visible on the final end-

product. The integrator of the module should refer to the labeling requirements for Korea available on the Korea

Communications Commission (KCC) website.

12.7 Australia/New Zealand (RCM)

DA14531 TINYTM Module has not been certified for the Australian/New Zealand market. However, the

module’s

CE test reports can be used in part to demonstrate compliance in accordance with Short Range Devices- SRD

Standards. The integrator of the module must construct a compliance folder with all relevant test reports: RF,

EMC, Electrical Safety and DoC (Declaration of Conformity).