MPC8358E datasheet(94/96 Pages) FREESCALE

94 / 96 page

MPC8358E PowerQUICC™ II Pro Processor Revision 2.1 PBGA Silicon Hardware Specifications, Rev. 1

Freescale Semiconductor

Document Revision History

and the I/O circuit takes on its normal function. Careful board layout with stubless connections to these

pull-up/pull-down resistors coupled with the large value of the pull-up/pull-down resistor should minimize

the disruption of signal quality or speed for output pins thus configured.

24.7

Pull-Up Resistor Requirements

The device requires high resistance pull-up resistors (10 k

Ω is recommended) on open drain type pins

including I2C pins, Ethernet Management MDIO pin, and EPIC interrupt pins.

For more information on required pull-up resistors and the connections required for the JTAG interface,

see AN3097, MPC8360E/MPC8358E PowerQUICC™ Design Checklist, Rev. 1.

25 Document Revision History

Table 78 provides a revision history for this hardware specification.

26 Ordering Information

Ordering information for the parts fully covered by this specification document is provided in

Section 26.1, “Part Numbers Fully Addressed by this Document.”

26.1

Part Numbers Fully Addressed by this Document

Table 79 provides the Freescale part numbering nomenclature for the MPC8358E. Note that the individual

part numbers correspond to a maximum processor core frequency. For available frequencies, contact your

local Freescale sales office. In addition to the processor frequency, the part numbering scheme also

includes an application modifier which may specify special application conditions. Each part number also

contains a revision code which refers to the die mask revision number.

Table 78. Document Revision History

Rev.

Number

Date

Substantive Change(s)

12/07/2007

Initial release.

MPC8358E Datasheet(PDF) 94 Page - Freescale Semiconductor, Inc