SDA

Start Condition

Stop Condition

SCL

S

P

SCL

SDA

data

change

allowed

data

valid

data

change

allowed

data

valid

data

change

allowed

LM3556

www.ti.com

SNVS796D – AUGUST 2011 – REVISED OCTOBER 2015

7.5 Programming

7.5.1 I2C-Compatible Interface

7.5.1.1 Data Validity

The data on SDA line must be stable during the HIGH period of the clock signal (SCL). In other words, state of

the data line can only be changed when SCL is LOW.

Figure 29. Data Validity Diagram

A pullup resistor between the controller's VIO line and SDA must be greater than [(VIO – VOL) / 3mA] to meet the

VOL requirement on SDA. Using a larger pullup resistor results in lower switching current with slower edges, while

using a smaller pullup results in higher switching currents with faster edges.

7.5.1.2 Start and Stop Conditions

START and STOP conditions classify the beginning and the end of the I2C session. A START condition is

defined as the SDA signal transitioning from HIGH to LOW while SCL line is HIGH. A STOP condition is defined

as the SDA transitioning from LOW to HIGH while SCL is HIGH. The I2C master always generates START and

STOP conditions. The I2C bus is considered to be busy after a START condition and free after a STOP condition.

During data transmission, the I2C master can generate repeated START conditions. First START and repeated

START conditions are equivalent, function-wise.

Figure 30. Start and Stop Conditions

7.5.1.3 Transferring Data

Every byte put on the SDA line must be eight bits long, with the most significant bit (MSB) transferred first. Each

byte of data has to be followed by an acknowledge bit. The acknowledge related clock pulse is generated by the

master. The master releases the SDA line (HIGH) during the acknowledge clock pulse. The LM3556 pulls down

the SDA line during the 9th clock pulse, signifying an acknowledge. The LM3556 generates an acknowledge

after each byte is received. There is no acknowledge created after data is read from the LM3556.

After the START condition, the I2C master sends a chip address. This address is seven bits long followed by an

eighth bit which is a data direction bit (R/W). The LM3556 7-bit address is 0x63. For the eighth bit, a '0' indicates

a WRITE and a '1' indicates a READ. The second byte selects the register to which the data will be written. The

third byte contains data to write to the selected register.

Copyright © 2011–2015, Texas Instruments Incorporated

Submit Documentation Feedback

17

Product Folder Links: LM3556