7 Application and Implementation

Note

Information in the following applications sections is not part of the TI component specification,

and TI does not warrant its accuracy or completeness. TI’s customers are responsible for

determining suitability of components for their purposes, as well as validating and testing their design

implementation to confirm system functionality.

7.1 Power Supply Recommendations

The power supply can be any voltage between the minimum and maximum supply voltage rating located in

the Recommended Operating Conditions. Each VCC terminal should have a good bypass capacitor to prevent

power disturbance. A 0.1μF capacitor is recommended for this device. It is acceptable to parallel multiple bypass

capacitors to reject different frequencies of noise. The 0.1μF and 1μF capacitors are commonly used in parallel.

The bypass capacitor should be installed as close to the power terminal as possible for best results.

7.2 Layout

7.2.1 Layout Guidelines

• Bypass capacitor placement

– Place near the positive supply terminal of the device

– Provide an electrically short ground return path

– Use wide traces to minimize impedance

– Keep the device, capacitors, and traces on the same side of the board whenever possible

• Signal trace geometry

– 8mil to 12mil trace width

– Lengths less than 12cm to minimize transmission line effects

– Avoid 90° corners for signal traces

– Use an unbroken ground plane below signal traces

– Flood fill areas around signal traces with ground

– For traces longer than 12cm

• Use impedance controlled traces

• Source-terminate using a series damping resistor near the output

• Avoid branches; buffer signals that must branch separately

7.2.2 Layout Example

W

W

≥ 5W

WORST

BETTER

BEST

Figure 7-1. Example Trace Corners for Improved Signal Integrity

www.ti.com

CD54AC299, CD74AC299, CD74AC323, CD54ACT299, CD74ACT299

SCHS288A – DECEMBER 1998 – REVISED DECEMBER 2024

Copyright © 2024 Texas Instruments Incorporated

Submit Document Feedback

11

Product Folder Links: CD54AC299 CD74AC299 CD74AC323 CD54ACT299 CD74ACT299