Product

Description

number

39004100

Stripper

39004160

Spare blades (2)

N/AL 9.12.005.02

06/97

WeldTube

Our policy is one of continuous research and development. We therefore reserve the right

to amend, without notice, the specifications given in this document.

Warning

These products are intended for use in industrial compressed air systems only. Do not use these products where

pressures and temperatures can

exceed those listed under ‘Technical Data’.

Before using these products with fluids other than those specified, for non-industrial applications, life-support systems, or other applications not

within published specifications, consult Norgren.

Through misuse, age, or malfunction, components used in fluid power systems can fail in various modes. The system designer is warned to

consider the failure modes of all component parts used in fluid power systems and to provide adequate safeguards to prevent personal injury or

damage to equipment in the event of such failure.

System designers must provide a warning to end users in the system instructional manual if protection against a failure mode cannot be

adequately provided.

System designers and end users are cautioned to review specific warnings found in instruction sheets packed and shipped with these products

where applicable.

General Information

138

This tube stripper ensures correct stripping of WeldTube

The colours are for the outer PVC cover

Tubing is supplied shrink-wrapped in 25m coils

Other colours can be supplied for orders of sufficient quantity

Tubing can also be supplied in longer lengths subject to economic order quantities

Tube Stripper

O/D

O/D

I/D

Working

Burst

Bend

Product number

Outer tube

Inner tube

Inner tube

pressure

pressure

radius

Black

Red

Green

Blue

mm

mm

mm

bar

bar

mm

8

6

4

10

30

40

WT4706025

WT4106025

WT4206025

WT4506025

10

8

6

10

30

50

WT4708025

WT4108025

WT4208025

WT4508025

12,5

10

7

10

30

65

WT4710025

WT4110025

WT4210025

WT4510025

14,5

12

9

10

30

75

WT4712025

WT4112025

WT4212025

WT4512025

To give full protection from weld spatter, the outer cover needs to be removed exposing the correct length of inner

tube for insertion into the WeldFit fitting.

The outer cover then fits into the collet counterbore, thus protecting system from spatter.

Instructions for Use

1. Ensure tube is cut at 90° to the tube axis. This cut to be in the middle

mark along tube.

2. Adjust cutting depth of stripper - adjust the cutting depth of the blade at the head screw and adjust to the outer

cover thickness.

3. Lift the clip against the spring pressure and insert tube, lining up blade with the next

mark from tube end (this

ensures correct length is removed.) Release the clip.

4. To strip outer cover, turn the tool radially around the tube to make a circular cut.

5. Turn the blade (90°) up to the stop with the lever. Move tool along the tube to make longitudinal cut.

6. The outer cover can be levered off with the aid of the ground edge of the clip and removed.