INA190 datasheet(23/48 Pages) TI2

23 / 48 page

DIFF

SENSE

DIFF

Error(%)

100

2 R

INA190

www.ti.com

SBOS863D – MARCH 2018 – REVISED NOVEMBER 2019

Product Folder Links: INA190

Submit Documentation Feedback

Application Information (continued)

As the voltage drop across the sense resistor (VSENSE) increases, the amount of voltage dropped across the input

filter resistors (RF) also increases. The increased voltage drop results in additional gain error. The error caused

by these resistors is calculated by the resistor divider equation shown in Equation 5.

where:

•

RDIFF is the differential input impedance.

•

RF is the added value of the series filter resistance.

(5)

The input stage of the INA190 uses a capacitive feedback amplifier topology in order to achieve high dc

precision. As a result, periodic high-frequency shunt voltage (or current) transients of significant amplitude (10

mV or greater) and duration (hundreds of nanoseconds or greater) may be amplified by the INA190, even though

the transients are greater than the device bandwidth. Use a differential input filter in these applications to

minimize disturbances at the INA190 output.

The high input impedance and low bias current of the INA190 provide flexibility in the input filter design without

impacting the accuracy of current measurement. For example, set RF = 100 Ω and CF = 22 nF to achieve a low-

pass filter corner frequency of 36.2 kHz. These filter values significantly attenuate most unwanted high-frequency

signals at the input without severely impacting the current sensing bandwidth or precision. If a lower corner

frequency is desired, increase the value of CF.

Filtering the input filters out differential noise across the sense resistor. If high-frequency, common-mode noise is

a concern, add an RC filter from the OUT pin to ground. The RC filter helps filter out both differential and

common mode noise, as well as, internally generated noise from the device. The value for the resistance of the

RC filter is limited by the impedance of the load. Any current drawn by the load manifests as an external voltage

drop from the INA190 OUT pin to the load input. To select the optimal values for the output filter, use Figure 33

and see the Closed-Loop Analysis of Load-Induced Amplifier Stability Issues Using ZOUT application report

INA190 Datasheet(PDF) 23 Page - Texas Instruments