STA1095 datasheet(53/127 Pages) STMICROELECTRONICS

53 / 127 page

DS13319 Rev 2

53/127

STA108x, STA109x

Electrical Characteristics

126

Electrical Characteristics

4.1

Parameter Conditions

Unless otherwise specified, all voltages are referred to GND.

4.2

Minimum and Maximum Values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with an ambient temperature at TA = 25°C and TA = 85°C.

The ‘Limit Values’ data is explained and identified with a letter as listed below, and reported

in the NOTE field of the following tables where applicable:



<SR>: System requirements, i.e.conditions that must be provided to ensure normal

device operation.



<P>: Data tested in production.



<C>: Data based on engineering characterization, not tested in production. Based on

characterization, the minimum and maximum values refer to sample tests and

represent the mean value plus or minus three times the standard

deviation (mean ± 3σ).



<V>: Data based on design validation performed on three sample devices, not tested in

production.



<S>: Data based on design guidelines and simulation, not tested in production.Typical

curves.

STA1095 Datasheet(PDF) 53 Page - STMicroelectronics