LM80 datasheet(14/29 Pages) NSC

14 / 29 page

Functional Description (Continued)

6.0 FAN INPUTS

Inputs are provided for signals from fans equipped with

tachometer outputs. These are logic-level inputs with an

approximate threshold of V

+/2. Signal conditioning in the

LM80 accommodates the slow rise and fall times typical of

fan tachometer outputs. The maximum input signal range is

0toV

+. In the event these inputs are supplied from fan

outputs which exceed 0 to V+, either resistive division or

diode clamping must be included to keep inputs within an

acceptable range, as shown in

Figure 7. R2 is selected so

that it does not develop excessive error voltage due to input

leakage. R1 is selected based on R2 to provide a minimum

input of 2V and a maximum of V

+. R1 should be as low as

possible to provide the maximum possible input up to V

+ for

best noise immunity. Alternatively, use a shunt reference or

zener diode to clamp the input level.

If fans can be powered while the power to the LM80 is off,

the LM80 inputs will provide diode clamping. Limit input

current to the Input Current at Any Pin specification shown in

the ABSOLUTE MAXIMUM RATINGS section. In most

cases, open collector outputs with pull-up resistors inher-

ently limit this current. If this maximum current could be

exceeded, either a larger pull up resistor should be used or

resistors connected in series with the fan inputs.

The Fan Inputs gate an internal 22.5 kHz oscillator for one

period of the Fan signal into an 8-bit counter (maximum

count = 255). The default divisor, located in the VID/Fan

Divisor Register, is set to 2 (choices are 1, 2, 4, and 8)

providing a nominal count of 153 for a 4400 rpm fan with two

pulses per revolution. Typical practice is to consider 70% of

normal RPM a fan failure, at which point the count will be

219.

Determine the fan count according to:

Note that Fan 1 and Fan 2 Divisors are programmable via

the Fan Divisor/RST_OUT/OS Register.

FAN1 and FAN2 inputs can also be programmed to be level

sensitive digital inputs.

Fans that provide only one pulse per revolution would re-

quire a divisor set twice as high as fans that provide two

pulses, thus maintaining a nominal fan count of 153. There-

fore the divisor should be set to 4 for a fan that provides 1

pulse per revolution with a nominal RPM of 4400.

LM80 Datasheet(PDF) 14 Page - National Semiconductor (TI)

LM80 Datasheet(HTML) 14 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Datasheet Download

Link URL