W209C
PRELIMINARY
Document #: 38-07171 Rev. *A
Page 3 of 16
Overview
The W209C is a highly integrated frequency timing generator,
supplying all the required clock sources for an Intel® architec-
ture platform using graphics integrated core logic.
Functional Description
I/O Pin Operation
Pin # 1, 10, 11, 12, 22, and 23 are dual-purpose l/O pins. Upon
power-up the pin acts as a logic input. An external 10-k
Ω strap-
ping resistor should be used. Figure 1 shows a suggested
method for strapping resistor connections.
After 2 ms, the pin becomes an output. Assuming the power
supply has stabilized by then, the specified output frequency
is delivered on the pins. If the power supply has not yet
reached full value, output frequency initially may be below tar-
get, but will increase to target once supply voltage has stabi-
lized. In either case, a short output clock cycle may be pro-
duced from the CPU clock outputs when the outputs are
enabled.
Offsets Among Clock Signal Groups
Figure 2 and Figure 3 represent the phase relationship among
the different groups of clock outputs from W209C when it is
providing a 66-MHz CPU clock and a 100-MHz CPU clock,
respectively. It should be noted that when CPU clock is oper-
ating at 100 MHz, CPU clock output is 180 degrees out of
phase with SDRAM clock outputs.
Power-on
Reset
Timer
Output Three-state
Data
Latch
Hold
QD
W209C
Clock Load
Output
Buffer
10k
Ω
Output
Low
Output Strapping Resistor
Series Termination Resistor
Figure 1. Input Logic Selection Through Resistor Load Option
CPU 66-MHz
SDRAM 100-MHz
3V66 66-MHz
PCI 33-MHz
REF 14.318-MHz
USB 48-MHz
APIC
0 ns
Figure 2. Group Offset Waveforms (66-MHz CPU Clock, 100-MHz SDRAM Clock)
40 ns
30 ns
20 ns
10 ns
SDRAM 100 Period
CPU 100 Period
Hub-PC
English ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
