10

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

10. Once the vehicle has started, turn the jumpstart ON/OFF switch OFF.

11. Disconnect the black negative (-) clamp first, then disconnect the red

positive (+) clamp.

12. After use, always wrap the cables around the post on the side of the

jumpstart body and clip the clamps into their positions on the clamp posts.

13. Return the 12V/24V selector to the 12V position

14. Return the ON/OFF switch to the OFF position after use.

15. After use, always recharge the jumpstart as described on page 12.

16. Regularly check the charge level of the battery by pressing the TEST push-

button on the front panel.

RECHARGING

Recharge the unit following each period of use. The unit must be charged at

least every 3 months but it is recommended that a ‘top-up’ charge is desirable

after every 30 days.

NOTE: Failure to do so will result in possible damage to the internal

battery and result in poor performance from partial failure to

operate due to the poor condition of the battery.

1. Insert the charger lead into the charging jack socket at the rear of the unit

2. Connect the mains adaptor to the mains outlet.

3. The 12V/24V selector switch must always be set to the 12V position while

charging in this way, otherwise the charge will not be received by both

batteries.

4. Check that the red CHARGING light illuminates and remains on during the

charging process.

• When the internal battery is fully charged, the green CHARGED light

will come on automatically.

5. The unit can now be unplugged for further use or storage, or it can be left

plugged in indefinitely so as to use its internal control to maintain the

optimum battery charge level.

WARNING: IT IS POSSIBLE THAT SOME ELECTRONIC EQUIPMENT COULD BE

DAMAGED BY JUMP STARTING. ALWAYS CHECK WITH THE CAR

MANUFACTURER’S HANDBOOK TO DETERMINE WHAT PRECAUTIONS IF

ANY SHOULD BE TAKEN.