3

Anti-Scale System Safety

Your safety and the safety of others are very important.

We have provided many safety messages in this manual and on your appliance. Always read and obey all safety

messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING”

These words mean:

You can be killed or seriously injured if you don’t

immediately follow instructions.

You can be killed or seriously injured if you don’t

follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell

you what can happen if the instructions are not followed.

In the state of Massachusetts: The Commonwealth of Massachusetts plumbing code 248-CMR shall

be adhered to. A licensed plumber shall be used for this installation.

IMPORTANT INFORMATION

=

Follow the installation instructions thoroughly.

Failure to install the system properly voids the war-

ranty.

=

Before you begin installation, read this entire

manual. Then obtain all the materials and tools

you will need to make the installation.

=

Check local plumbing codes. The installation must

conform to them.

=

Use only lead-free solder and flux for all sweat-

solder connections as required by state and

Do not return the Anti-Scale System to store.

If you have any questions, or there are missing parts or damage, please call Toll Free 1-866-986-3223

or visit www.whirlpoolwatersolutions.com

When you call, please be prepared to provide the model and serial number, located on the rating decal on

back of the cover.

federal codes.

=

Use care when handling the system. Do not turn

upside down, drop, or set on sharp protrusions.

=

Recommended maximum allowable inlet water

pressure is 125 psi (8.8 kg/cm2). Use a pressure

reducing valve if necessary.

=

This system is not intended to be used for treating

water that is microbiologically unsafe or of

unknown quality without adequate disinfection

before or after the system.